[WARNING]: Could not match supplied host pattern, ignoring: unprovisioned PLAY [Deploy initial device configuration] ************************************* TASK [Set variables that cannot be set with VARS] ****************************** ok: [s1] ok: [h1] ok: [h2] ok: [h3] ok: [h4] TASK [Find device readiness script] ******************************************** ok: [s1] ok: [h1] ok: [h2] ok: [h3] ok: [h4] TASK [Wait for device to become ready] ***************************************** skipping: [s1] skipping: [h1] skipping: [h2] skipping: [h3] skipping: [h4] TASK [Deploy initial configuration] ******************************************** included: /home/pipi/net101/tools/netsim/ansible/tasks/deploy-module.yml for s1, h1, h2, h3, h4 TASK [Figure out whether to deploy the module initial on current device] ******* ok: [s1] ok: [h1] ok: [h2] ok: [h3] ok: [h4] TASK [Find configuration template for initial] ********************************* ok: [s1] ok: [h1] ok: [h2] ok: [h3] ok: [h4] TASK [Print deployed configuration when running in verbose mode] *************** ok: [h1] => msg: |- initial configuration for h1 ========================================= #!/bin/bash # # This script contains the 'ip' commands needed to set up container # interfaces and route table. It's executed within the container # network namespace on the container host. # # /etc/hosts file is generated as a clab bind. # set -e ### One-Shot configuration (non-Ubuntu VM or container) # # Disable IPv4 and IPv6 forwarding # sysctl -w net.ipv4.ip_forward=0 sysctl -w net.ipv6.conf.all.forwarding=0 # # Interface addressing # ip link set dev eth1 up set +e ip addr del 172.16.0.1/24 dev eth1 2>/dev/null set -e ip addr add 172.16.0.1/24 dev eth1 ip link set eth1 mtu 1500 # # Add routes to IPv4 address pools pointing to the first neighbor on the first link # # If you need anything better, use FRR instead of Linux and start routing (or use IPv6) # # # Print the final routing table ip route ok: [s1] => msg: |- initial configuration for s1 ========================================= #!/bin/bash # set -e set -x # # Create bash profile script # cat <